Here we go again. This 6 inch capacity SO CALLED self-centering jig from TASK-USA or Telco tools is another example of lousy workmanship.
Another so called made in the USA centering jig that?s off by unacceptable tolerances.
If I wanted this kind of inaccuracy, I would use the drill press witout my glasses.
They claim their jig is within 10000 ?5000 tolerance, I guess they need to get back to school or learn to use a calculator. 10000 is = 0.0001 and 5000 = 0.0002.
My measurement shows 1/100 =0.01. sad part is, they didn’t even attempt to replace the unit claiming all their jigs are like this and are within tolerances.
Even harbor freight was more accurate than this. Well, I give up. the retailer at (eagleamerica.com) told me they tested few more of these and there was no point in sending me a replacement since the other ones they had in stock were ever more off then the one they sent me. funny thing is they even raised the price.
Save your cash and buy made in china. It?s all same junk!!
Keine Kommentare:
Kommentar veröffentlichen