Drilling a hole in pen blanks has become a frustrating problem. When I drill a hole thru the pen blank, it starts in the center at the top but exits the blank off center at the bottom. I tried to turn the pen blank anyway but it usually blows apart at the very end of the turning process. Obviously, this is very frustrating. I use a dedicated 10er in the drill press mode to drill the hole. I locate the center of the blank with 2 diagonal lines and use a center punch to create a hole to insert the brad point drill bit. When I drill the hole, I clear the wood shavings quite often. I also use a Rockler centering jig to hold the blank at 90 degrees to the table.
Any and all suggestions to resolve this problem are welcome.
Freitag, 17. Dezember 2010
Drilling pen blanks
Abonnieren
Kommentare zum Post (Atom)
Keine Kommentare:
Kommentar veröffentlichen