After having this saw for about 9 months, and using the heck out of it, I have noticed that the blade is not at 90- degrees – front to back. That means is is leaning back about 1/32 of an inch on the top side vs. the bottom (at the table). This was most noticable yesterday when cutting a 3-D compound cut and the cutouts were different size one side vs. the other. Now the almost useless product manual is of not help with this problem and previous attempts with Porter Cable have also been useless (they do not make the saw). They do address and have adjustment for left to right out of alignment issues. I looked for any type of adjustment or reposition of the blade but it seems that this is not the answer. I have not found a post that addresses this issue.
Does anyone who has this saw have a answer or directions to available information.
Source: http://lumberjocks.com/reviews/2154
vertical horizons treehouse paradise dexter season 5 episode 5 clay matthews
Keine Kommentare:
Kommentar veröffentlichen