One of my Christmas presents contained the hubs and pulleys to rebuild my power honer. This is based on the Burke sharpener that is available commercially. It is 15” wide (24” at the top), 11” deep, and 19” at the top of the wheels. I used a 1/2 HP 1725 rpm motor that is reduced to about 300rpm with 6” pulley. The discs are 8” x 1” and two are covered in sandpaper with 120 and 220 grit. The other wheel is covered in leather and used with honing compound and a 6 inch spiral-sewn buffing wheel completes the outfit. I was very pleased with how smoothly the wheels run after truing them up on my disk sander. The sandpaper is a little aggressive at the moment, but should be fine after it wears a bit. Once I have the profile and edge like I want it, I polish the ouside to a mirror finish and remove the wire edge on the inside with the buffing wheel.
Source: http://lumberjocks.com/projects/58212
brian wilson the machine vertical horizons treehouse paradise wwe bragging rights live stream
Keine Kommentare:
Kommentar veröffentlichen